215676
105
Revision A
1009104
CXXX
MXXX
HAY CONDITIONER
NO/YES
A
B
C
Figure 3.107: Hay Conditioner Activation
4.
Press SELECT (C) until HAY CONDITIONER? appears on the
upper line.
•
NO/YES will appear on the lower line.
5.
Press right arrow (B) to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (C) to proceed to the next WINDROWER SETUP
option.
Displaying Reel Speed
The preferred header reel speed can be set by accessing the HEADER REEL SPEED sub-menu in the WINDROWER SETUP
menu in the windrower
’
s cab display module (CDM).
NOTE:
•
This procedure applies to windrowers with an attached draper or auger header only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
.
To display the header
’
s reel speed:
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.108: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
