215676
100
Revision A
1009257
CXXX
MXXX
DWA AUTO UP / DOWN?
NO/YES
D
C
B
A
Figure 3.95: DWA Auto Up/Down
7.
Press right arrow (C) to select YES. Press SELECT (D).
•
DWA AUTO UP/DOWN? appears on the upper line.
•
NO/YES appears on the lower line.
NOTE:
If YES is selected, the DWA Auto-Up function will be
activated by the GSL reel fore-aft button.
8.
Press right arrow (C) to select YES. Press SELECT (D).
9.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next windrower setup option.
Activating Hydraulic Center-Link
Once the hydraulic center-link has been installed on the windrower, it must be activated in the cab display module
’
s (CDM)
WINDROWER SETUP menu.
NOTE:
This procedure requires installation of the optional Hydraulic Center-Link kit(MD #B4650).
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.96: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? appears on the upper line.
•
NO/YES appears on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009072
CXXX
MXXX
TILT CYL INSTALLED?
NO/YES
C
B
A
Figure 3.97: CDM Programming Buttons
4.
Press SELECT (C) until TILT CYL INSTALLED? appears on the
upper line.
•
NO/YES appears on the lower line.
5.
Press right arrow (B) to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (C) to proceed to next WINDROWER SETUP action.
