215676
98
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.90: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
1009259
CXXX
MXXX
AUTO RAISE HEIGHT?
4.0
D
C
B
A
Figure 3.91: Auto Raise Height
4.
Press SELECT (D) until AUTO RAISE HEIGHT? appears on the
upper line.
•
The current auto raise height setting will appear on the
lower line.
NOTE:
The auto raise height setting ranges from 4.0 (minimum) to
9.5 (maximum), and can be adjusted in increments of 0.5. A
setting of 10 disables the auto raise function.
5.
Press left arrow (B) or right arrow (C) to change the auto
raise height.
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Configuring Double Windrow Attachment Controls
Once the Double Windrow Attachment (DWA) is installed on the windrower, it must be configured to work with the
windrower
’
s controls. The DWA can be configured in the cab display module
’
s (CDM) WINDROWER SETUP menu.
NOTE:
•
The DWA cannot be activated if the swath compressor is enabled.
•
This procedure is also applicable to the installation of a drive manifold kit (MD #139508) onto the windrower.
