215676
92
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.78: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear.
•
The current knife speed will appear on the lower line.
1009144
CXXX
MXXX
SET KNIFE SPEED
#### SPM
D
C
B
A
Figure 3.79: Knife Speed Setting
4.
Press left arrow (B) or right arrow (C) to select knife speed.
Press SELECT (D).
5.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
action.
Setting Knife Overload Speed
The knife overload speed setting determines the reported header knife speed at which a knife overload speed warning will
appear on the cab display module (CDM). By default, this is 75% of the configured header knife speed, but this setting can
be changed by accessing the KNIFE OVERLOAD SPD sub-menu in the WINDROWER SETUP menu.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module automatically
adjusts its programming for each header. For more information, refer to
4.5 Attaching and Detaching Headers, page
.
•
The recommended knife overload speed is 75% of knife speed.
