215627
43
Revision A
%
&
'
$
Figure 4.5: Constant Torque Clamps
3.
Check three constant torque hose clamps (A) and spring
clamp (B) on the turbocharger intake duct. Clamp (B) is
properly tightened when screw tip (C) extends beyond the
housing and Belleville washers (D) are almost flat.
4.1.3
Checking and Adding Engine Oil
Check the engine oil level and watch for any signs of leakage.
NOTE:
The engine oil level can be checked without opening the hood.
$
Figure 4.6: Engine Oil Dipstick Location
1.
Locate the engine oil dipstick on the right side of the
windrower. Remove dipstick (A) by turning it
counterclockwise to unlock it.
2.
Wipe the dipstick clean and reinsert it into the engine.
Figure 4.7: Engine Oil Level on Dipstick
3.
Remove the dipstick again and check the oil level. The oil
level should be between the LOW (L) and HIGH (H) marks
on the dipstick. If the oil level is below the LOW mark, you
will need to add oil.
NOTE:
Adding 1.9 liters (2 U.S. quarts) of engine oil will raise the
level from LOW to HIGH.
4.
Replace the dipstick and turn it clockwise to lock it.
