MacDon M105, Operator'S Manual

Page: 223 / 384

MAINTENANCE AND SERVICING
5.6 Windrower Lubrication
WARNING
To avoid personal injury, before servicing windrower or opening drive covers, follow procedures in the
SAFETY section.
The greasing points are marked on the machine by
decals showing a grease gun and grease interval in hours
of operation.
Log hours of operation and use the Maintenance Checklist
provided to keep a record of scheduled maintenance.
Refer to
Maintenance Schedule/Record, page 315
.
Figure 5.29: Lubrication Interval Decal
5.6.1 Lubricating the Windrower
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. To avoid injecting dirt and grit, wipe grease fi tting with a clean cloth before greasing.
2. Inject grease through fi tting with grease gun until grease over fl ows fi tting, except where noted. Refer to
Lubricants, Fluids, and System Capacities, page 199
.
3. Leave excess grease on fi tting to keep out dirt.
4. Replace any loose or broken fi ttings immediately.
5. If fi tting will
NOT
take grease, remove and clean thoroughly. Also clean lubricant passageway. Replace fi tting
if necessary.
169890
209
Revision A