UNLOADING AND ASSEMBLY
Form 169558
Revision A
21
STEP 10. ATTACH HEADER
A. HEADER ATTACHMENT - D SERIES
IMPORTANT
A light header float kit may need to be
installed, depending on the header
size and configuration.
IMPORTANT
To prevent damage to the lift system
when lowering header lift linkages
without a header or weight box
attached to windrower, ensure that
float engagement pin is installed in
storage location (A), and not installed
at hole location (B).
a. If not installed, attach draper header boots
(supplied with header) to windrower lift linkage
as follows:
1. Remove hairpin, and remove pin (C) from
boot (D).
2. Locate boot (D) on lift linkage (E), and
re-install pin (C). Pin may be installed from
either side of boot.
3. Secure pin (C) with hairpin.
4. Repeat for opposite side.
b. Remove hairpin on pins (F), and remove pins
from header legs.
CAUTION
Check to be sure all bystanders have
cleared the area.
(continued next page)
C
D
F
B
A
D
E
C
Summary of Contents for M105
Page 2: ...Form 169558 Revision A MACDON M105 SELF PROPELLED WINDROWER ...
Page 50: ......
Page 52: ......
Page 53: ......