215620
199
Revision A
$
Figure 5.179: HPT Display
10. Press soft key 3 (A) to remove the header float.
NOTE:
If the header float is active, the icon at soft key 3 displays
Remove Float; if the header float has been removed, then
the icon displays Resume Float.
$
%
&
'
(
)
Figure 5.180: GSL
A - Reel Down
B - Reel Up
C - Header Tilt Down
D - Header Tilt Up
E - Header Down
F - Header Up
11. Press HEADER DOWN switch (E) on the ground speed
lever (GSL) to fully retract the header lift cylinders.
12.
Windrowers equipped with a self-aligning hydraulic
center-link:
Press REEL UP switch (B) on the GSL to raise the
center-link until the hook is above the attachment pin on
the header.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
$
%
Figure 5.181: Header Support
13. Drive the windrower slowly forward until feet (A) enter
supports (B). Continue to drive slowly forward until the feet
engage the supports and the header is nudged forward.
14. Ensure that feet (A) are properly engaged in supports (B).
