215620
146
Revision A
5.2.2
Attaching D1X or D1XL Series Draper Header
The windrower may have an optional self-aligning hydraulic center-link, which allows control over the vertical position of
the center-link from the cab. If the windrower is so equipped, the procedure for attaching the header will differ slightly.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
Draper header supports must be installed onto the windrower lift linkage before starting this procedure. For instructions,
refer to
5.2.1 Attaching Draper Header Supports, page 145
.
1.
Shut down the engine, and remove the key from the ignition.
$
%
%
Figure 5.40: Forming Shield bracket
–
R85
$
%
Figure 5.41: Forming Shield bracket
–
R2 Series
2.
If an R85 or R2 Series Rotary Disc Header is also used, the
forming shield support brackets that are attached to the
windrower lift legs must be removed to avoid contacting
the draper header as follows:
a.
Remove hardware (B).
b.
Remove support bracket (A). Place the bracket and
hardware in the toolbox.
