MacDon M 2014 Series, Original Instruction

Page: 67 / 238

ASSEMBLING THE WINDROWER
17. Retrieve the two motor case drain
hoses (MD #111312) (A) at front frame, and the
7/8 in.(22 mm) tee fitting (B) on the hose (C) from
the pump.
18. Remove caps from the hoses (B) only.
19. Remove one cap on tee fitting (A) and quickly attach
hose (B) to minimize oil spillage.
20. Remove second cap from tee (A) and quickly connect
other hose (B).
21. Tighten fittings.
22. Push hoses into frame.
Figure 6.34: Hose Routing
23. Secure hoses with cable ties (A) as required.
Figure 6.35: Hose Routing
6.6.2 Installing Hydraulics on an M155
1. The hydraulic hoses under the cab may require proper
placement under the existing clip.
If necessary,
proceed as follows:
a. Locate hose clip (A) under the cab and remove clip.
b. Position hose (MD #111323 [orange tie]) and
hose (MD #111324 [white tie]) with tee, as shown
under the center of the clip, and loosely install
two bolts and nuts. Part numbers are located on
hoses. (If M200, place another hose (MD #1132A)
with tee under clip).
c. Position remaining hoses under clip as shown and
tighten bolts.
Figure 6.36: Hose Routing
169886
57
Revision A