MacDon HC10, Setup, Operation, And Parts Manual

Page: 81 / 186

215593
71
Revision A
1. Shut down the engine, and remove the key from
the ignition.
$
%
Figure 4.37: Forming Shield Strap at Wheel Leg
2. Remove hairpins (A) securing straps (B) to pins on
windrower frame.
3. Support aft end of forming shield. Adjust the shield height
using the holes in the straps.
4. Secure straps with hairpins.
Adjusting Side Deflectors
The position of the side deflectors controls the width and placement of the windrow.
DANGER
To avoid injury or death from unexpected start-up of the machine, always stop the engine and remove the key from
the ignition before leaving the operator
’
s seat for any reason.
1. Shut down the engine, and remove the key from
the ignition.
$
%
&
Figure 4.38: Side Deflector
–
Right
2. Set side deflectors (A) to the desired width by loosening
handle (B) and moving deflector (A). Tighten the handle.
Repeat at opposite side. Set both deflectors to
approximately the same position.
IMPORTANT:
To ensure windrow placement is centered with respect to
windrower wheels, adjust both side deflectors to the same
position. To achieve this setting, adjuster handles must be
in the same location on both sides.
3. If side deflector attachment is too tight or too loose,
tighten or loosen nut (C) as required.
Adjusting Rear Deflector (Fluffer Shield)
The rear deflector slows the crop exiting the conditioner rolls, directs the flow downward, and fluffs the material.
DANGER
To avoid injury or death from unexpected start-up of the machine, always stop the engine and remove the key from
the ignition before leaving the operator
’
s seat for any reason.
OPERATION