MacDon HC10, Original Instruction

Page: 108 / 242

215126
86
Revision A
1. Shut down the engine, and remove the key from the ignition.
2. Engage the header safety props.
1002810
A
B
Figure 5.19: Drive Belt Cover
3. On the left side of the conditioner, remove wing nut and
washer (A), and then remove drive cover (B).
1030917
A
A
B
C
D D D
A
Figure 5.20: Drive Pulley
–
Conditioner Drive Motor
5. Turn tensioning nut (B) counterclockwise to loosen.
6. Remove belt (C).
NOTE:
If drive pulley is loose, was removed, or was replaced for
any reason, tighten three bolts (D).
5.7.5 Installing Drive Belt
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine and remove
key before leaving the operator
’
s seat, and always engage safety props before going under the machine for any reason.
NOTE:
Before installing a new belt, refer to 5.7.3 Checking and Adjusting Drive Belt Tracking, page 84 to check possible cause of
failure.
1. Shut down the engine, and remove the key from the ignition.
2. Engage the header safety props.
MAINTENANCE