MacDon HC10, Operation And Parts Manual

Page: 52 / 156

UNLOADING AND ASSEMBLY
3.10 Installing the Forming Shield
To install the forming shield, follow these steps:
1. Position the forward end of the forming shield (A)
onto the two pins (B) located on the rear cover of the
conditioner.
Figure 3.60: Forming Shield
2. Insert lynch pins (A) to secure forming shield to
conditioner.
Figure 3.61: Lynch Pin
3. Set forming shield side deflectors to desired width by
loosening handle (A) and moving deflector (B). Set
both deflectors to approximately the same position.
4. Tighten handles (A).
5. Loosen handles (C) and adjust fluffer shield (D) to
middle position.
6. Tighten handles (C).
Figure 3.62: Forming Shield
214033
42
Revision A