MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 59 / 354

214685
47
Revision A
Figure 4.35: Wide Configuration (Right Side)
2. Remove two bolts and access cover (A).
3. Remove hardware (B), and bolt-on flighting (C).
4. Install flighting slot plugs (MD #213084) in the flighting
mounting locations (D) and secure with M6 bolts
(MD #252703) and tee nuts (MD #197263).
5. Repeat at the left side of the auger.
6. Install additional auger fingers. A total of 30 fingers are
recommended for this configuration. Refer to
4.2.10
Installing Feed Auger Fingers, page 54 .
4.2.8 Converting from Medium Configuration or Wide Configuration to
Ultra Narrow Configuration
Four kits of either MD #287032 or B6400 and some hole-drilling are required to convert to the Ultra Narrow
configuration. Extra hardware is included in these kits. Be sure to use the correct hardware in the correct location to
prevent damage and to maximize performance.
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to the header operator
’
s manual or technical manual.
NOTE:
Some parts have been removed from the illustrations for clarity.
Figure 4.36: Wide Configuration (Right Side)
2. Remove bolts (A) and access cover (B) from the right
side of the auger. Retain for reassembly.
3. Remove hardware (C) and bolt-on flighting (D) from
the auger.
4. Remove the flighting slot plug (E) located close to the
end of the flighting (D).
5. Converting from Medium configuration: Repeat
above steps for the other bolt-on flighting on the
same side.
SETTING UP FLOAT MODULE