MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 219 / 354

214685
207
Revision A
Setting Cutting Height (CLAAS 500 Series)
Cutting heights can be programmed into the preset cutting height and auto contour systems. Use the preset cutting
height system for cutting heights above 150 mm (6 in.), and use the auto contour system for cutting heights below
150 mm (6 in.).
Setting Preset Cutting Height (CLAAS 500 Series)
CAUTION
Check to be sure all bystanders have cleared the area.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
1. Start the engine.
2. Activate the machine enable switch.
3. Engage the threshing mechanism.
4. Engage the header.
Figure 7.119: Control handle Buttons
5. Briefly press button (A) in order to activate the auto
contour system, or briefly press button (B) in order to
activate the preset cutting height system.
NOTE:
Button (A) is used only with auto header height control
(AHHC) function. Button (B) is used only with the return
to cut function.
Figure 7.120: CLAAS Combine Controls
6. Use the < key (C) or > key (D) to select the CUTTING
HEIGHT screen, and press the OK key (E).
7. Use the
–
key (A) or the + key (B) to set the desired
cutting height. An arrow indicates the selected cutting
height on the scale.
SETTING UP AUTO HEADER HEIGHT CONTROL