MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 217 / 354

214685
205
Revision A
7.1.7 CLAAS 500 Series Combines
Calibrating the Auto Header Height Control (CLAAS 500 Series)
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set
to
D . When setup and calibration are complete, adjust the center-link back to desired header angle. Refer to
Header Angle in the header operator
’
s manual for instructions.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
NOTE:
If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for
calibration procedure so header doesn
’
t separate from the float module.
1. Ensure center-link is set to D .
Figure 7.114: CLAAS Combine Controls
2. Use the < key (A) or > key (B) to select AUTO
HEADER, and press the OK key (C). The E5 screen
displays whether the automatic header height is on
or off.
Figure 7.115: CLAAS Combine Controls
3. Use the
–
key (A) or the + key (B) to turn the AHHC on,
and press the OK key (C).
4. Engage the threshing mechanism and the header.
SETTING UP AUTO HEADER HEIGHT CONTROL