MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 452 / 510

MAINTENANCE AND SERVICING
4. Disconnect the hydraulic lines (A) at the motor (B). Cap
or plug open ports and lines.
NOTE:
Mark the hydraulic lines (A) and their locations in the
motor (B) to ensure correct reinstallation.
5. Remove four nuts and bolts (C) and remove the
motor (A). Retrieve the spacer (not shown) from
between the motor (B) and the motor mount
(if installed).
Figure 5.271: Reel Motor and Hoses
Installing Reel Drive Motor
1. Slide the motor mount (A) up or down so the motor
mounting holes (B) are accessible through the
openings in the chain case.
Figure 5.272: Reel Drive Motor Mounting Holes
2. Attach the motor (A) (and spacer if previously removed)
to the motor mount (B) with four 1/2 in. x 1-3/4 in.
countersunk bolts and nuts (C).
3. Torque nuts (C) to 54 ft·lbf (73 N · m).
4. If installing a new motor, install the hydraulic fi ttings
(not shown) and torque to 81–89 ft · lbf (110–120 N · m).
Figure 5.273: Reel Drive Motor
147831
434
Revision A