MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 340 / 510

MAINTENANCE AND SERVICING
5.4.4 Changing Oil Filter
Change the oil fi lter after the fi rst 50 hours of operation and every 250 hours thereafter.
Obtain fi lter part MD #202704 from your MacDon Dealer.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1. Clean around the mating surfaces of the fi lter (B) and
manifold (A).
2. Remove the spin-off fi lter (B) and clean the exposed
fi lter port in the manifold (A).
3. Apply a thin fi lm of clean oil to the O-ring provided with
the new fi lter.
4. Turn the new fi lter into the manifold (A) until the O-ring
contacts the mating surface. Tighten the fi lter an
additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do
NOT
use a fi lter wrench to install the new
fi lter. Overtightening can damage the O-ring
and fi lter. Figure 5.30: FM100 Hydraulics (Cover Opened
to Show Manifold)
147831
322
Revision A