Calibrating Feeder House Fore/Aft Tilt Range (John Deere S and T Series)
For best performance of the auto header height control (AHHC), perform these procedures with the center-link
set to D. When setup and calibration are complete, adjust the center-link back to desired header angle. Refer to
This procedure applies only to model year 2015 and later John Deere S and T Series combines.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
The feeder house fore/aft tilt is controlled by buttons (C)
and (D) at the back of the hydro handle.
Figure 3.242: John Deere Hydro Handle
NOTE:
The feeder house fore/aft tilt controls can be changed to
work with buttons E and F by pressing the hydro handle
icon (A) and then selecting FEEDER HOUSE FORE/AFT
TILT from the drop-down menu (B).
Figure 3.243: John Deere Combine Display
To calibrate the feeder house fore/aft tilt range, follow
these steps:
1. Ensure center-link is set to D.
2. Rest header on down stops and unlock
fl
oat
module
fl
oat.
3. Place wings in locked position.
147831
163
Revision A
Summary of Contents for FlexDraper FD1 Series
