214325
260
Revision A
5.1.15
New Holland Combines (CR Series
–
Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other
New Holland combine models, refer to
5.1.14 New Holland Combines CX/CR Series (CR Series
Engaging Auto Header Height Control (New Holland CR Series)
This procedure applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90).
For best performance of auto header height control (AHHC), perform these procedures with center-link set to D.
When setup and calibration are complete, adjust center-link back to desired header angle.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
Figure 5.261: New Holland Combine Display
1.
Ensure center-link is set to D.
2.
Select TOOLBOX (A) on main page. The TOOLBOX
page displays.
Figure 5.262: New Holland Combine Controls
3.
Simultaneously press both UNLOAD (A) and
RESUME (B) buttons on hydro handle.
