MacDon D65, Operator'S Manual

Page: 218 / 310

214327
198
Revision B
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
1. Raise the reel fully.
2. Lower the header fully.
3. If hydraulic deck shift is installed: Shift the decks to create work space at one end of the header.
4. Shift the decks to allow work space at one end of the header if hydraulic deck shift is installed. Otherwise, move the
decks manually after shutting down the windrower.
5. Shut down the engine, and remove the key from the ignition.
6. Engage the reel safety props. For instructions, refer to Engaging Reel Safety Props, page 33 .
7. If hydraulic deck shift is NOT installed: Move the decks manually to create work space at one end of the header.
1009954
A
B
C
D
E
F
Figure 5.145: Deflector Support
8. Open the endshield. For instructions, refer to Opening
Endshield, page 35 .
9. Loosen bolts (A) on the cutterbar until retainer (B) is loose.
10. Remove the existing bolt that secures belt guide (C) on the
opposite side of the endsheet.
11. Position support (D) as shown, and reinstall bolt (E) with
the nut on the far side.
12. Install a second 3/8 in. x 3/4 carriage bolt (F) and lock nut.
Do NOT tighten the bolts.
1009952
C
C
A
B
D
Figure 5.146: Wide Deflector
13. Position deflector (A) as shown and adjust the forward edge
for best fit on the cutterbar. Slide the deflector under
retainer (B).
14. Loosely install seven 3/8 in. x 3/4 carriage bolts (C) with
lock nuts to attach the deflector to the endsheet. Bolt
heads must face inboard.
15. Adjust the position of the deflector to obtain the best fit at
the cutterbar and the aft edge. Tighten bolts (C) as required
to maintain the best fit.
16. Tighten bolts (D) on retainer (B). Torque the bolts to 88 Nm
(65 lbf·ft).
MAINTENANCE AND SERVICING