MacDon D65, Installation Instructions Manual

Page: 62 / 74

169784
56
Revision H
3.16 Tow-Bar Brackets
The tow-bar is stored on the header just behind the backtube. It is secured to each endsheet with a bracket and to the
backtube with two cradles.
The 9.1 m (30 ft.) D65 Draper Header uses a different bracket on the right endsheet from other models. Both bracket types
are included in the kit.
3.16.1 Installing Bracket on Left Endsheet
Install the tow-bar bracket on the left endsheet as follows:
1011880
A
B
C
Figure 3.90: Left Endsheet
A - Bracket B - Carriage Bolts
C - 55 mm (2 3/16 in.)
1. At the left endsheet inboard side, install bracket (A)
(MD #193188) on channel with two 3/8 NC x 3/4 in.
carriage bolts (B) and flanged smooth-faced nuts.
3.16.2 Installing Bracket on Right Endsheet
–
9.1 Meter (30 Foot) D65 Headers
This procedure only applies to 9.1 m (30 ft.) D65 Draper Headers. For instructions on installing the tow-bar bracket on the
right endsheet of any other model, refer to
3.16.3 Installing Bracket on Right Endsheet
–
Headers Except the 9.1 Meter (30
Foot) D65 Headers, page 58 .
1011885
A
Figure 3.91: Right Endsheet
1. At the right endsheet inboard side, remove the bolt and
harness clip at location (A) that attaches the wiring harness
to the endsheet.
NOTE:
An overlay for the pilot hole drilling template provided in
the kit is shown in the illustration at right.
INSTALLATION INSTRUCTIONS