169441
223
Revision D
1010346
A
B
C
C
Figure 4.205: Reel Motor and Hoses
7.
Disconnect hydraulic lines (A) at motor (B). Cap or plug
open ports and lines.
NOTE:
Mark hydraulic lines (A) and their locations in motor (B) to
ensure correct reinstallation.
8.
Remove four nuts and bolts (C) and remove motor (B).
Retrieve the spacer (not shown) from between motor (B)
and the motor mount (if installed).
Installing Reel Drive Motor
The reel drive motor does not require regular maintenance or servicing. If problems occur with the motor, remove it and
have it serviced at your MacDon Dealer.
1012846
A
B
C
Figure 4.206: Reel Drive Motor
1.
Attach motor (A) to motor mount (B) with four countersunk
bolts and nuts (C).
NOTE:
The bolts should be inserted through holes and slots in the
chain case into the motor mount.
2.
Torque nuts (C) to 102 Nm (75 lbf
∙
ft).
1012847
B
C
A
Figure 4.207: Reel Motor and Hoses
3.
Remove the caps or plugs from the ports and lines, and
connect hydraulic lines (A) to hydraulic fittings (B) on
motor (C).
NOTE:
Ensure hydraulic lines (A) are installed at their original
locations.
4.
Install the drive sprocket. For instructions, refer to
Replacing Reel Drive Sprocket, page 215
.
5.
Reinstall the reel drive cover. For instructions, refer to
Installing Reel Drive Cover, page 204
.
Summary of Contents for D50
Page 101: ...169441 89 Revision D 10 Tighten bolts B OPERATION ...
Page 124: ......
Page 295: ...topsoil moisture 83 types 80 weather and topography 83 WOT definition 19 INDEX ...
Page 296: ......