UNLOADING AND ASSEMBLY
Form # 169007
Model Year - 2009
7
STEP 1. UNLOAD HEADER
CAUTION
To avoid injury to bystanders from being
struck by machinery, do not allow persons to
stand in unloading area.
CAUTION
Equipment used for unloading must meet or
exceed the requirements specified below.
Using inadequate equipment may result in
chain breakage, vehicle tipping or machine
damage.
LIFTING VEHICLE
HDR SIZE
15-25
30-45
Min. Lifting Capacity *
5000 lb
(2270 kg)
7000 lb
(3178 kg)
Min. Fork Length
78 in. (1981 mm)
* At 48 in. (1220 mm) from back end of forks.
IMPORTANT
Forklifts are normally rated for a load
located 24 in. (610 mm) ahead of
back end of the forks. To obtain the
forklift capacity at 48 in. (1220 mm),
check with your forklift distributor.
a. Move trailer into position and block trailer
wheels.
b. Lower trailer storage stands.
CAUTION
Ensure that forks extend beyond the inner
support prior to lifting the header. If the
forks do not lift at the supports, damage to
the header may occur.
c. Approach the header and slide forks in
underneath lower structure as far as possible.
d. Remove hauler's tie down straps and chains.
WARNING
Be sure forks are secure before moving away
from load. Stand clear when lifting.
e. Raise windrower off deck.
f. Back up until unit clears trailer and slowly lower
to 6 in. (150 mm) from ground.
g. Take machine to storage or set-up area.
h. Repeat above steps for second header.
i. Check for shipping damage and missing parts.
TOPSIDE
UNDERSIDE
