PRE-DELIVERY INSPECTION
Form # 169007
Model Year - 2009
25
H. REEL TINE TO CUTTERBAR
CLEARANCE
a. Adjust fore/aft reel position so that back end of
cam disc is approximately between 4 and 5 on
the arm decal.
b. Fully lower the reel.
c. Rotate reel manually to determine which finger
is closest to cutterbar (within 12 in. (300 mm) of
endsheets.
d. Flex fingers back as shown to check clearance
“X”. Refer to chart for allowable clearances.
“X” +/- 0.12 in. (3 mm)
At Endsheets
“X” +/- 0.12 in. (3 mm) At
Sectors Next to Drive At
Center Arm
0.78 in. (20 mm)
1.56 in. (40 mm)
e. If required, adjust outside reel arms as follows:
1. Loosen bolt (A).
2. Turn cylinder rod (B) counter-clockwise to
raise reel and increase clearance to
cutterbar, or clockwise to decrease.
3. Tighten bolt (A).
4. Repeat at opposite side.
f. If applicable, adjust center arm as follows:
1. Loosen nut (C).
2. Turn nut (D) clockwise to raise reel and
increase clearance to cutterbar, or counter-
clockwise to decrease.
3. Tighten bolt (C).
A
B
C
D
LOOKING UP AT
ARM
UNDERSIDE
DOUBLE REEL
“X”
