Removing Narrow Draper Deflectors
Narrow draper de
fl
ectors can replace wide de
fl
ectors if bunching occurs at the ends of the header when decks
are set for center delivery.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
1. Raise the reel to its full height and lower the header to the ground.
2. Shift the decks to create a work space at one end of the header if hydraulic deck shift is installed; otherwise,
move the decks manually after shutting down the windrower.
3. Stop the engine, remove the key, and engage the reel safety props.
4. Open the endshield. Refer to
.
5. Remove two Torx
®
head screws (A) and lock nuts.
6. Remove three carriage bolts (B) and lock nuts and
remove the aft de
fl
ector (C).
Figure 5.148: Aft Deflector
7. Remove four screws (A) and remove the de
fl
ector (B).
8. Repeat for the opposite end of the header.
Figure 5.149: Forward Deflector
214044
173
Revision A