1. Use a Phillips screwdriver to remove the screws (A)
from the
fi
xture, and remove the plastic lens.
2. Replace the bulb, and reinstall the plastic lens
and screws.
NOTE:
Use bulb trade #1156 for amber transport
lights and #1157 for red tail light (Slow Speed
Transport option).
Figure 5.16: Transport Light
5.4.2
Checking and Adjusting Reel Height Sensor
The output voltage range of the auto reel height sensor can be checked from inside the windrower or manually
at the sensor. For in cab instructions, refer to the windrower operator’s manual. To check the voltage range
manually, refer to the procedure below.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Ensure reel height is properly set before adjusting reel height sensor. Refer to
.
IMPORTANT:
To measure the output voltage of the reel height sensor, the windrower needs to be turned ON and supplying
power to the sensor. Always engage the combine parking brake to and stay away from the reel.
Table 5.4 Reel Height Sensor Voltage Limits
Voltage Range
Power Unit
X Voltage
Y Voltage
M1 Series Windrower
0.5–0.9 V
4.1–4.5 V
NOTE:
For Lexion Combines: To avoid a collision of the reel with the cab, the machine is equipped with an automatic
reel height limitation. When raising the header by more then 80 percent, the reel is automatically lowered. The
automatic lower of the reel can be overridden manually, and a warning will appear on the CEBIS terminal.
1. Engage the windrower parking brake.
2. Start the windrower engine and lower reel fully.
214044
114
Revision A