215184
440
Revision A
Setting Preset Cutting Height
–
John Deere S and T Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1023870
A
B
C
D
Figure 9.295: Float Indicator Box
NOTE:
Indicator (A) should be at position 0 (B) with the header
(152 mm [6 in.]) off the ground. If not, the float sensor
output voltage should be checked. Refer to Step
. When the header is on the ground, the indicator
should be at position 1 (C) for low ground pressure, and at
position 4 (D) for high ground pressure. Crop and soil
conditions determine the amount of float to use. The ideal
setting is as light as possible without header bouncing or
missing crop. Operating with heavy settings prematurely
wears the cutterbar wearplates.
1003954
A
Figure 9.296: Combine Display
1.
Press COMBINE
–
HEADER SETUP icon (A) on the main
screen. The COMBINE
–
HEADER SETUP screen appears.
This screen is used to set various header settings such as
reel speed, header width, and height of feeder house for
acre counter engagement.
1003955
A
Figure 9.297: Combine Display
2.
Select COMBINE
–
HEADER SETUP AHC icon (A). The
COMBINE
–
HEADER SETUP AHC screen appears.