215184
12
Revision A
2.3
Moving to Assembly Area
To move headers to the assembly area using a forklift or a crane, follow one of these procedures:
2.3.1
Forklift Method
WARNING
Equipment used for loading and unloading must meet or exceed the minimum specified requirements. Using
inadequate equipment may result in vehicle tipping, machine damage, or chain breakage.
NOTE:
Forklifts are normally rated for a load located 610 mm (24 in.) ahead of back end of the forks. To obtain forklift capacity at
1220 mm (48 in.), check with your forklift distributor.
For minimum lifting equipment requirements, refer to
12.3 Lifting Equipment Requirements, page 515
IMPORTANT:
Ensure that forks extend beyond cutterbar prior to lifting header. If forks do not lift at cutterbar, damage to header
may occur.
1017270
A
B
Figure 2.14: Fork in Slider Channels
1.
Approach header and line up forks (A) with fork slider
channels (B).
NOTE:
When possible, approach from the underside to minimize
potential for scratching the unit.
2.
Slide forks (A) as far as possible without contacting the
shipping supports of the opposite header.
1017001
Figure 2.15: Header on Level Ground
3.
Raise header off platform and set it down securely on level
ground. Ensure ground is flat and free of rocks and debris
that could damage the header.