215184
232
Revision A
1024737
A
B
Figure 7.64: Float Lock Handle
16. Disengage the float locks by pulling each float lock
handle (A) away from the float module, and setting it in
unlocked position (B).
NOTE:
Illustration at right shows the right side of the header. Float
lock on left side of header opposite.
7.5.2
Installing Reel Fore-Aft / Header Tilt Switch
–
S and T Series Combines
The reel fore-aft/header tilt switch allows the combine Operator to select either reel FORE-AFT or HEADER TILT mode.
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
This procedure is applicable to John Deere S and T Series combines. For John Deere 60 or 70 Series combines, refer to
Installing Reel Fore-Aft / Header Tilt Switch
60 and 70 Series Combines, page 239
Prepare the combine cab for switch and harness installation as follows:
1.
Lower and tilt the combine feeder house all the way forward if equipped. This will ensure that the electrical harnesses
will be installed with sufficient slack.
2.
Shut down the engine, and remove the key from the ignition.
3.
Disconnect the negative cable from the combine battery. For instructions, refer to the combine manual.
IMPORTANT:
If you do not disconnect the battery before connecting the cab draper control harness to the combine
’
s auxiliary
power connectors, electrical components may be damaged.
