MAC215986
386
Revision A
1012873
A
B
Figure 4.213: Draper Connector
21. Close the feed draper and secure it with connector
straps (B), screws (A), and nuts.
22. Tension the feed draper. For instructions, refer to
Checking and Adjusting Feed Draper Tension, page 373
Replacing Feed Draper Idler Roller Bearing
The feed draper idler roller bearing helps the roller turn. The bearing needs to be removed when replacing it.
NOTE:
Procedure is the same for both sides. Left side is shown.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
1.
Raise the reel fully.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 33
.
5.
Engage the header
’
s safety props. For instructions, refer to the combine operator
’
s manual.
B
1027877
A
Figure 4.214: Feed Draper Tensioner
6.
To release the draper tension, loosen jam nut (A) and turn
bolt (B) counterclockwise. Repeat at the opposite side of
the header.
