MAC215986
186
Revision A
Installing Crop Dividers
Follow these instructions to properly instal the crop dividers.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1.
Start the engine.
2.
Lower the reel fully.
3.
Raise the header fully.
4.
Shut down the engine, and remove the key from the ignition.
5.
Engage the header safety props. Refer to the combine operator
’
s manual for instructions.
1029352
A
B
C
Figure 3.269: Optional Crop Divider
6.
If optional storage bracket is installed. Remove crop
divider (A) from storage position by lifting the crop divider
so that bolt (B) clears the slot in storage bracket (C).
7.
If not installed, retrieve crop dividers from where they were
stored.
8.
Open the endshield. For instructions, refer to
1029248
A
B
C
Figure 3.270: Crop Divider with Latch
9.
Insert crop divider lugs (A) into holes in the endsheet
as shown.
10. Remove lynch pin (B) from latch (C).
