MAC215986
182
Revision A
1029779
A
B
Figure 3.262: Initial Position of Adjustable Mounts
–
Three-Piece Auger
1029784
A
A
B
B
1
2
Figure 3.263: Adjustable Mount Details
1 - Two-Piece Auger Mount
2 - Three-Piece Auger Mount
A - Primary Position for Front Bolt
B - Secondary Position(s) for Front Bolt
When the front bolt is moved to secondary position (B), the
auger position can be adjusted to a greater extent. For three-
piece augers, additional secondary positions (B) are available if
you wish to raise or lower the auger. When the front bolt is in
one of these positions, the fore-aft adjustment is limited, which
prevents the UCA from interfering with the feed auger and the
header frame.
IMPORTANT:
When the front bolt is in one of secondary positions (B) and the
reel is in its rear-most position, the reel fingers and cam arms
may contact the UCA. When the reel is moved fully back (for
example, when harvesting canola), the UCA must also be moved
fully back in order to allow for sufficient clearance between the
reel fingers and the auger.
Move the auger forward to
•
Help convey light crops, especially on side hills
•
Improve the feeding of light crops
•
Reduce the reel carry over or the crop flow disruption
caused by the reel
Move the auger rearward to
•
Increase the available volume for conveying heavy crop
•
Keep the auger close to the deflectors to prevent crop from
getting behind the auger and wrapping around the auger
