MacDon A40-D, Operator'S Manual

Page: 85 / 240

214804
71
Revision A
3.6.8 Setting Cutting Height
CAUTION
To prevent accidental movement of windrower, return ground speed lever (GSL) to Park, center steering
wheel to lock, shut off engine, and remove key.
Figure 3.102: Skid Shoe
1. Raise header, and engage header lift cylinder lock-out
valves.
2. Remove pins (A) at each skid shoe or gauge roller.
3. Raise or lower skid shoe or gauge roller to desired
position.
4. Replace pins (A).
Figure 3.103: Gauge Roller
5. Check that skid shoes or gauge rollers are adjusted to the same position.
6. Check header float, and adjust if required. Refer to 3.6.9 Checking/Adjusting Float
–
M Series, page 72 for
more information.
NOTE:
The two inboard skid shoes are standard equipment. The inboard shoes can be moved to the outboard position
OR outboard positions can be fitted with either gauge rollers or skid shoes.
OPERATION