PRE-DELIVERY CHECKS
Form # 169078
Model Year - 2009
36
E. LEVEL THE HEADER
a. Park windrower on level ground.
b. Increase header angle to maximum with header
tilt switch in tractor.
c. Lower header onto ground so that linkage (A)
lifts at tractor leg. If necessary, place wooden
blocks under header cutterbar and header legs.
d. Shut down the engine and remove the key.
e. Remove nut, washer and bolt (B) that attaches
shims (C) to link at the header high end.
f. Remove one or both shims (C) and reinstall the
hardware (B).
g. Check level of header.
h. If additional levelling is required, install the
removed shim on the opposite linkage.
NOTE
If required, additional shims are available
from your dealer.
NOTE
Float does not require adjustment after
levelling header.
B
A
C
