8
MITRE AND ANGLE CUTS
Loosen the rotating table locking lever then lift up
the locking knob and rotate the table to the
desired angle. Release the locking knob and
re-secure the table locking lever. Start the saw
and make the cut through the material in a
smooth action.
WARNING. Be sure to tighten the table locking
lever before making a cut. Failure to do so could
result in the table moving during the cut, causing
serious personal injury.
BEVEL CUTS
Loosen the bevel locking lever and tilt the saw
head over to the desired angle. Re-secure the
bevel position locking lever. Start the saw and
make the cut through the material in a smooth
action.
WARNING. Be sure to tighten the bevel locking
lever before making a cut. Failure to do so could
result in the saw arm moving during the cut,
causing serious personal injury.
COMPOUND CUTS
A compound cut is a combination of both mitre
and bevel cuts. Loosen the rotating table locking
lever. Set the desired mitre angle and re-secure
the rotating table locking lever. Loosen the bevel
position locking lever and set the desired bevel
angle. Re-secure the bevel position locking lever.
Start the saw and make the cut through the
material in a smooth action.
WARNING. Be sure to tighten the mitre and bevel
locking levers before making a cut. Failure to do
so could result in the table and/ or saw arm
moving during the cut, causing serious personal
injury.
TABLE SAW MODE
TURNING THE SAW ON & OFF
To start the machine, lift the emergency stop cover
and press the green ON button. To stop the
machine, press the red OFF button. In the event
of an emergency, hit the emergency stop cover,
this will switch the machine OFF and will
mechanically lock the emergency stop cover in
place preventing the machine from being switched
on until the mechanical lock has been released.
To release the mechanical lock depress the
emergency button and slide it upwards.
29, 30 & 31
CROSS CUTTING
Cross cutting is cutting wood across the grain at
90° or square with both the edge and the flat side
of the wood.
MITRE CROSS CUTTING
Mitre cross cutting is cutting the wood at an angle
other than 90° with the edge of the wood. Follow
the same procedures as you would for cross
cutting. But adjust the mitre gauge to the desired
angle.
BEVEL CROSS CUTTING
Bevel cross cutting is the same as cross cutting
except that the wood is also cut at an angle other
than at 90° with the flat side of the wood. Follow
the same procedures as you would for cross
cutting. But adjust the blade to the desired angle.
Use the mitre gauge in the groove to the left of the
blade to avoid the blade guard from interfering
with the cross cutting.
WARNING!
When cross cutting, mitre cutting, bevel cutting
and when rabbeting across the end of a narrow
work piece always use the mitre gauge. NEVER
make these cuts freehand (not using the mitre
gauge or the other devices) because the blade
could bind causing a kickback or causing your
hand or fingers to contact the blade.
ALWAYS lock the mitre gauge when in use.
Remove the rip fence from the table when not in
use.
Make sure the blade safety guard is mounted for
all through sawing operations (the blade cuts
through the entire thickness of the work piece).
The blade should extend approximately 3.5mm
(1/8”) above the top of the work piece.
COMPOUND MITRE CUTTING
Compound mitre cutting is a combination of mitre
cutting and bevel cross cutting.
The cut is made at an angle other than 90° to both
the edge and the flat side of the wood.
Adjust the mitre gauge and the blade to the
desired angle and be sure that the mitre gauge is
locked.
REPETITIVE CUTTING
Repetitive cutting is cutting a number of pieces the
same length, without having to mark each piece.
32
33
34
35
36
37
38
39