PAGE | 01
Installation Instructions
User Manual
ADA Grab Bar Series
Models:
GB-36 & GB-42
36” Grab Bar for ADA Application
42” Grab Bar for ADA Application
Stainless Steel Construction
Concealed mounting for a clean look
1-1/4" bar diameter
2-1/2" flange diameter
Bar extends 1-1/2" from wall
Supports up to 250 lbs.
Meets ADA load requirements when properly installed
All hardware necessary for satisfactory installation
Package Includes
8
66 558 3200 310 919 3073 Info@mac
fauc
ets.com www.mac
faucets.com
M
AC FAUCETS
Calif
ornia, USA
DE
S
IGNED &
A
SS
E
MB
LED IN TH
E U
S
A
Tools Needed
Safety Glasses
Drill bit
Ø 1/4” Carbide
Drill for tile
Cordless Drill
Level
Phillips Screw Driver
Pencil
Stud Finder
Level
02
Unscrew flanges and pull back from the two ends of the
grab bar. Position the grab bar so that the mounting
ends are against the studs. Make sure the bar is leveled.
Mark drill hole locations.
01
M
ark The studs
Stud
Finder
F
OR SAFETY
REASONS, GRAB
BARS MUST
MOUNT TO STUDS
ONLY. With the stud
finder tool, locate
and mark position of
the studs.
Important notes for proper Installation
DO NOT INSTALL
this product without reading and understanding the warning instructions. If you are unable
to understand these warnings and instructions, contact professional or technical personnel for assistance-
otherwise injury may occur.
GRAB BAR LOCATION
For proper mounting heights and location, consult with your state and local code official, they have jurisdiction
over the installation
SOLID SUPPORT
* Grab Bar ends must be mounted with both end position over a wall stud. Stud finder must be used to locate
wall studs, Contractor is responsible for installing Grab Bar to wall studs as instructed.
* Secure through wallboard or tile to the wall so as to hold a minimum of 250 pounds.
* At least two (2) of the three (3) wood screws provided must be used on each end of the Grab Bar, top and
bottom, to properly secure Bar to wall. Standard size wall studs limit using more than two (2) wood screws.
* If using a drill to install wood screws, a drill bit extension must be used to avoid damaging the Grab bar.
