Mac allister 3902202967, Original Instructions Manual

Page: 18 / 110

18
General Safety
–
A guard or other part that is damaged should be properly repaired or
replaced by an authorized service centre unless otherwise indicated in
this instruction manual.
–
Have defective switches replaced by an authorized service centre.
–
Do not use the tool if the switch does not turn it on and off.
21. Warning
–
The use of any accessory or attachment other than one recommended
in this instruction manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person
–
This electric tool complies with the relevant safety rules. Repairs should
only be carried out by qualified persons using original spare parts,
otherwise this may result in considerable danger to the user.
23. Before further use of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an authorized
service center unless other- wise indicated elsewhere in this instructions
manual. Have defective switches replaced by an authorized service
center. Do not use tool if switch does not turn it on and off.
It is imperative that the following situations are avoided at all times:
• When the cutterblock is blocked due to abnormal feed force during
cutting, turn the machine off and disconnect it from power supply.
Remove the work piece and ensure that the cutter block runs free. Turn
the machine on and start new cutting operation with reduced feed force.
• Check the machine and carry out required maintenance work on it each
time before you start it up. In particular, inspect all the anti-kick claws that
they are free moving and return to their initial position after lifting.
• Damaged or soiled workpieces may cause a risk of danger. Never use
metal parts in the machine or any materials which can fracture or shatter.
Risk of injury!
• Use a push stick to plane any short workpieces.
• If a push stick is not used there may be a risk of serious danger. The push
stick should always be kept at the point provided on the left-hand side of
the machine when not used.
GB
MPTP1500B MAC
Getting
started...
Safety