4
Please do not leave the machine running unattended or unused for more than 3 minutes.
WARNING:
When the machine is running, please maintain a constant water supply. Without
water circulation will damage the sealing rings of the machine.
WARNING:
It is necessary to turn on the spray lance within one or two minutes after the
machine has been started. Otherwise, the temperature of the circulating water within the machine
will soon rise to a critical point, which will cause damage to the sealing rings inside the machine.
WARNING:
Don’t start and run the machine in a place excessively cold so as to prevent the
machine from the freezing current.
WARNING:
This machine has been designed for only using cleaning water, do not use corrosive
chemicals.
WARNING:
Use cleaning agent supplied or recommend by the manufacturer.
WARNING:
High-pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, animals, live electrical equipment or
the machine itself. Pressure washers should not be pointed at tire walls, as
it may be possible to damage them.
WARNING:
Do not direct the jet against yourself or others in order to clean clothes or footwear.
WARNING:
Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or
similarly qualified person to avoid a hazard.
WARNING:
Do not use the machine if a supply cord or important parts are damaged, e.g. safety
devices, high pressure hoses, trigger gun.
WARNING:
Be aware of the recoil caused by the water jet when the machine is switched on.
WARNING:
When the machine is moving and installing, the machine must be in flat.
When
moving the machine, pulling the handle to move it.
WARNING:
Connect to the water supply. The machines are not suitable for connection to
portable water mains. Connect the machine to the water supply. (It can be a water container).
Make sure the inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at
least 5 M long. Do not use the pipe if the pipe is damaged. If you want connect this machine to
portable water mains, you must install a backflow preventer in the water pipe to prevent dirty
water flow back to the drinking water system. The backflow preventer shall comply with EN
60335-2-79 ANNEX AA.
OPERATING INSTRUCTIONS
!
This unit is to be connected to a cold water source
ONLY
.
!
The motor of this pressure washer will NOT run. It will only operate when the trigger is
squeezed.
Summary of Contents for APW-VSA-150P
Page 9: ...8 ELECTRICAL DIAGRAM ...
