SM10
P. 6 / 8
EM-6342-B
http://www.m-system.co.jp
SETTING FLOWCHART
POWER SUPPLY ON
■
INITIAL SETTING FLOW CHART
INITIAL SETTING COMPLETE
Set the following parameters in the setting mode.
• Retroactive time
• Transition ramp rate
• LED brightness
Power Supply ON
PV Input
PV LED
ON at startup
Measuring in progress
■
SETTING MENU
When the power supply is turned on, the SM10 starts at the measuring mode.
Pressing and holding the indication selector button (IND button) for longer then 3 seconds turns the module into the setting mode.
Measuring stopped
*
1
Mode transition
Back to Measuring Mode
Retroactive
Time
ON
SETTING MODE
IND
IND
Press
IND
Press/Hold
for 3 sec.
OUT
Press/Hold
for 1 sec.
OUT
Press/Hold
for 1 sec.
CAS Input
CAS LED
ON
IND
Press
Press
IND
IND
Press
Press
Transition
Ramp Rate
ON
MV Input
Back to PV input
MV LED
ON
IND
Press
MEASURING MODE
*
1. Value before interruption is held.
Output Manual Switching
CAS/MAN LED
CAS
MAN
LED status at the last state
before power interruption is
reproduced
(above: CAS input to MV output)
RA
IND
Press/Hold
for 3 sec.
LED
Brightness
Blinking
RA
RR
Output Mode Switching
CAS/MAN LED
CAS
MAN
Pressing OUT button reverses
the previous LED status.
(above: MV output by UP/
DOWN operation button
setting)
IND
OUT
IND Button
OUT Button
