If it is decreased continuously to none position, then, it is
the power off position (namely, the motor stops operation.)
5. Timer key “ ”:
1.The timer key is the timer setting key if the timer key doesn’t
work at both the position and indicator.
①
Long press timer key for 2-3 seconds, time segment
, and the first two hour bit segment flash, use
key for the digit increase, and use key for the digit
decrease. Namely: The variable is 01 each time it is
pressed; the hour segment is with the largest digit of 23.
If it exceeds 23, key is null and void. If it is equal to
00, then, the key is null and void.
②
Press the timer key for the 2
nd
time , time segment
, and the last two minute bit segment flash, use key
for the digit increase, and use key for the digit
decrease. Namely: The variable is 01 each time it is
pressed; the minute segment is with the largest digit of
59. If it exceeds 59, key is null and void. If it is equal
to 00, then, the key is null and void.
③
Press the timer key for the 3
rd
time, and it is the time
setting exit and confirm key.
④
Long press timer key for 2-3 seconds under this
operation mode, and it is for the hour setting; Press it
for the 2
nd
time: Setting for the minute; Press it for the
3
rd
time: For the time setting exit and confirm, and it
will be repeated again and again (if the 1
st
time pressing
doesn't exceed 2 seconds, then it can't run this operating
procedure.)
2.The timer key is the timer if the timer key works at either the
position or the indicator.
①
It is provided with three kinds of time segment, and they
are 5min/15min/30min/timer cancel in sequence, and
the 1
st
time is 5min, the 2
nd
time is 15min, the 3
rd
time is
30min, the 4
th
time is timer cancel, the 5
th
time is 5min,
and the 6
th
time is 15min …., and it will be repeated
again and again.
②
Example: Let the setting time be 15min, the display is
00:15, 00:14, …00:1, with 0:00 displays per minute,
and once “00: 00” appears, the motor position and the
1
2
Summary of Contents for MSK-650
