150
47DAC OPERATING MANUAL EM-9518-B Rev.4
16. ADJUSTING DISPLAY REFRESHING RATE
The 47DAC measures input signal at the read rate 50 milliseconds. The display refreshing rate can be slower than this
rate (figure below) within the range of 0.1 to 99.9 seconds. With this value set to 00.0, the refreshing rate will be the same
as the read rate (50 milliseconds) (table below). When the input signal changes rapidly, the display refreshing rate can be
slowed to suppress the display flickering.
■
DISPLAY REFRESHING RATE
MAIN DISPLAY
FUNCTION
DEFAULT VALUE
50 milliseconds
to
0.1 to 99.9 seconds
■
DISPLAY REFRESHING IMAGE
e.g. Refreshing rate 0.2 seconds
NOTE
The display refreshing rate setting affects the DC output when the analog output function mode is set to “proportional to
the display value”. Refer to 8. SETTING ANALOG OUTPUT for details.
Display value
Measured value
Minimum interval of display refreshing rate
50 milliseconds