M K Martin Enterprise PULSAR 120, Operator And Parts Manual, Page: 10 / 28

Setup Information
With the deck flat on a firm surface and the cylinder retracted the hitch should be at draw-bar
height. The hitch control rods can be adjusted for some height variation,. You may need to ad-
just the tractor draw-bar height as well.
After finishing the adjustment, measure to ensure that pin to pin measurement is equal on both
control rods.
Control Rod
Control Rod Pins
Hitch Leveling Bars
Adjustment can be done
At both ens if necessary
To Adjust Control Rod
Loosen jam nut
Remove Control Rod Pin
Screw Yoke in or out on the Control Rod for proper ad-
justment.
Ensure that there is a minimum of 1” of thread inside the
yoke, and that nothing will bind or interfere as the cylin-
der goes through it’s full range.
Secure the jam-nuts.