Maintenance
26
IDM 510-074-1
English language
Operation and maintenance manual
Scheduled maintenance intervals
Always keep the machine in optimum operating condition and carry out the routine
maintenance according to the intervals and procedures specified by the Manufac-
turer.
– In case of prolonged inactivity, carry out some maintenance operations in order to
preserve functionality and prevent further damages.
– After prolonged inactivity, carefully check that the operating functionality has remained
unaltered.
– A good maintenance will ensure a stable performance over time, longer working life
and constant compliance with the safety requirements.
Maintenance schedule
Every working day
Component
Operation required
Procedures to implement
Machine
Check of safety devices
- Make sure that the listed devices are efficient.Emergency stop
button.
- Main electric disconnector
- Cutting blade protection
Every 40 work hours (max 1 week)
Component
Operation required
Procedures to implement
Sealing machine and
unit
Cleaning
- Remove dirt and residues with the use of a suitable vacuum
system.
- Use a clean, dry (not abrasive) cloth.
Sealing units
Cutting blade cleaning
- Clean the cutting blade (See “Cleaning the cutting blade”).
- Spread a thin layer of lubricant on blade in order to avoid the
accumulation of glue residues and to preserve it from rust.
Every 600 work hours (max 3 months)
Component
Operation required
Procedures to implement
Machine
Lubrication of head adjusting
screw
- Paint with grease (See “Diagram of the points of lubrication”).
Sealing units
Lubrication of rollers:
- Use grease spray (See “Diagram of the points of lubrication”).
Every 1200 work hours (max 6 months)
Component
Operation required
Procedures to implement
Machine
Check of conveyor belts
- Check the state of wear of the belts.
- Replace the belts in case they are excessively worn. (See “Lower
conveyor belt replacement” - “Replacement of upper conveyor
belts”).
Machine
Check of conveyor belt driving
pulley rings
- Check the rubber ring for wear.
- Replace the component, if it is worn out
Machine
Lubrication of conveyor belt
transfer chain
- Lubricate all the greasing points (See “Diagram of the points of
Sealing units
Check of cutting blade
- Check the state of wear of the blade.
- Replace the component if there are signs of wear (See “Replacing
the cutting blade”).
Sealing units
Check of springs
- Check the spring efficiency.
- Replace the springs if the case inlet and outlet rollers do not return
correctly to their position.
Sealing units
Check of rollers:
- Check the state of wear of the rollers.
- Replace the component, if worn
