M-E ODYON proWE10/24, Instruction Manual

Page: 24 / 32

Push" operating mode
Slide the operating mode selector switch to the "Push" position.
Press the button for channel 1 (5), the channel 1 LEDs light up red and green, and
then press the desired button on the hand-held transmitter. The red and green
LEDs flash once for confirmation and then go out.
How exactly the contact now behaves when the button on the hand-held trans-
mitter is pressed depends on the setting of the two potentiometers (8) and (9). If
both potentiometers are turned to position 0, the contact switches ON as long as
the button on the hand-held transmitter is pressed and OFF when the button on
the hand-held transmitter is released. You can read how the two potentiometers
influence this behaviour in the next two sections.
Potentiometer switch-off delay (8)
With this potentiometer, the switch-off delay can be set between 0 and 10
seconds. In position 0 the relay switches off without delay. By turning the poten-
tiometer clockwise, the time is adjusted continuously up to a maximum of 10
seconds. I.e. 10 seconds after the relay has switched on, it automatically switches
OFF again.
Potentiometer switch-on delay (9)
With this potentiometer, the switch-on delay can be set between 0 and 10
seconds. In position 0, the relay switches on without delay when the correspond-
ing button on the hand-held transmitter is pressed. By turning the potentiometer
clockwise, the time is adjusted continuously up to a maximum of 10 seconds. I.e.
10 seconds after the corresponding button on the hand-held transmitter is
pressed, the relay switches ON.
NOTE: If a delay is set and the button on the hand-held transmitter is pressed,
the receiver will not respond to the hand-held transmitter button being pressed
again until the delay time has elapsed.
NOTE: You can switch between the "Toggle" and "Push" operating modes at any
time. If the "2-channel" mode is to be or has been set, the wall receiver must be
reset as described in the next section.
Repeater function
This wall receiver can also be used as a repeater. Briefly press the repeater button
and then the button on the hand-held transmitter that is to be forwarded.
EN
24