M Design RD 1000, Instructions For Installation And Use Manual

Page: 3 / 14

3
1 GENERAL
1.1 TRANSPORT AND INSTALLATION

The LUNA RD is transported in a horizontal position or if there are some problems – in angle-wise
45
°.

To make transport easier you can use a set of transport holders.

The transport holders fix to the correct position behind the set screws of the stove. /Pic.1/.

The steps for unlocking of the door : Unscrew screws 1 and 2 /Pic.2/
Behind the cover are placed screws M8, which is needed to unscrew. /see Pic.3/ after unscrewing the
screws M8 is necessary to screw cover back with screw 1 and 2. /Pic.2/
For security reasons, the door is locked from both left and right site!

Before installation of the stove, please check lifting door – lifting up/down and opening /see Pic.4/
1.2 FUEL
1.2.1 Recommended fuel: Wood-hard, soft-damp cca.16%
The quality of the wood is extremely important for the optimal function of the stove /output, clear glass,
etc.../. The ideal is to use dried wood with moisture content 12% to 18%. Damp wood gives off less heat, clogs
the chimney and the glass of the fireplace´s door. You can also use briquettes and it is better to use them in
combination with wood.
Pic.1
Set screws
Transport holders
Screw 1
Screw 2
Pic.2
Pic.3
Screw M8
Pic.4