M Design LUNA HC Series, Instructions For Installation And Use Manual, Page: 11 / 19

11
4 GENERAL RECOMMENDATIONS
The device must be connected and tested before there is doing the surround. To make sure the equipment is
working optimally, they must be cured with tubes isolated. They must meet the minimum diameter of the tube
with hot air / flue / a diameter of a heat. Do not place flammable materials in close proximity to the fireplace
insert. Note: If you leave the door open, a small piece of burning wood / carbon / may fall to the floor. Insulation
materials: it is preferable to use high temperature resistant materials. It is very advantageous position to connect
the chimney and fireplace so that no moisture or water do not get inside. Moisture and water can cause skamolex
swells and then bursts when the fire start.
4.1 MAINTANCE
in addition to regular cleaning of glass, must be your chimney at least once a year sweep to insert
optimal function. / It's not just a legal requirement, but it also makes sense for your own safety /.
Refractory bricks / babble / may still work perfectly, even if they are cracked. However, if the missing
pieces of bricks, bricks must be replaced in order to effectively protect the combustion chamber.
To remove the ash residue can to use the ash / ash /
Cleaning the flue gas flow routes easily convert – lean out the heat-bridge 1 towards you / look out from
behind the bridge, the founder ash / Convert .This cleaning do at least once a month during the heating
season. In the case of rough may be clogging the roads flue can result in poor combustion and excessive
fumigation. Pic.17 / 17a.
Säuberung
Abb.17a
Fallende Aschel
Way of lean out the bridge
Pic.17
Bridge 1