M Confort MF60, User Manual

Page: 18 / 48

14
V. HOW TO USE
1-. The oscillation angle of the fan is 90˚ from left to right.
2-. The high and low angle of the fan is 10˚. It is adjustable. Loosen the lock nut,
adjust the motor to the desired angle and tighten the nut.
3-. Adjust the speed: press the bottom of the remote control or the electrical box
of the pillar to control the gears.
4-. Remote control:
a-. The nebulizer fan is in sleep mode when it is on, the buzzer sounds
once.
b-. Press ON / SPEED to start. The fan starts at medium speed for 3
seconds and then goes at low speed. Press the ON / SPEED button again to switch
between the two speeds.
c-. Press the off button to turn off the fan.
d-. Set the timer: Press TIMER to start the timer function, 30 min, 1h, 2h,
3h, 4h. The led on the remote control shows the selected configuration.
e-. Press the OSCILLATION SWITCH key to start the oscillation function,
press again to deactivate the oscillation function, the led will indicate the
configuration.
f-. Press the MIST ON / OFF button to start the nebulization, press again
to turn it off, the LED will indicate the configuration.
g-. The operating distance of the remote control is less than 8 meters.
The buzzer sounds twice to start, sounds a second to go off and beeps to perform
a function.
5-. Lift the tank lid and fill the tank with clean water. Make sure that the pump
hose is completely submerged in water. A maximum operating time of 6 hours is
possible with a full tank and with an average fogging rate. Fill the tank when the
nebulization flow is no longer sufficient.
6- When moving the nebulizer, DO NOT force when pushing the tank car before
opening the wheel brake. Close the brake when the eventilator stops.
7- Clean the tank before every use. Remove the water pump before cleaning,
discard the water after cleaning.
MCONFORT MF60