24
DIRECT ACCESS
To directly access a selection, enter the corresponding number (i.e. 4)
followed by SEL to activate the selection. The entered number is displayed on
line two as shown below. Line one shows the current list being used for
selection.
S E L S Y S
4
If a mistake is made while entering the number, press the
DEL
button to
backspace once and correct the entry. If an invalid number is entered, a short
low-pitched tone sounds when
SEL
is pressed.
To exit the selection mode, press the
c
button or wait for the time-out. If
the selection mode is cleared while an entry is pending (i.e., numbers are
entered on line 2, but
SEL
has not been pressed), the entry on line two will be
disregarded and the previous selection will remain active. If the time-out
activates while an entry is pending, the entry on line two will be selected if it
is within the valid range; if it is out of range, the entry on line two will be
disregarded and the previous selection will remain active.
NOTE:
While in system, group or channel selection mode, the radio
continues to receive calls normally and continues scanning if it is enabled. If a
call is received during the selection mode process the radio will return to the
normal receive mode display. Continuing with the selection process will
return the display to the same point in the selection process if the selection
mode time out has not yet expired. Any press of the PTT button during the
selection mode process will initiate transmission and exit the selection mode.
MENU
The menu function accesses features that is not available directly from the
keypad. The order and specific number of menu items available is
configurable through programming. Upon radio power up, the menu item that
is at the beginning of the menu list will always be displayed first. Subsequent
access to the menu function will return the last menu item that was shown in
the display. To enter the menu mode, press
m
. The RAMP control
,
and
.
, the
SEL
and the
c
buttons are used during the selection process. All
of the selection mode rules previously detailed apply to the menu item
selection process with the exception of direct access. The radio will continue
to receive and transmit normally while in the menu function.
A new item is displayed by using the RAMP control
,
and
.
to scroll
through the list in increasing and decreasing order. The displayed menu item
is made active by pressing
SEL
.
