SA3-RGB
Sound Activated RGB
LED Tape Controller
Item ref: 153.740UK
User Manual
Version 1.0
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for your choice of SA3-RGB controller to connect with your low voltage multi-colour
LED installation. This accessory has been designed to give dynamic and sound-activated
control to the light output, adding colour and life to architecture, signage or furniture. Please
read this manual to get the best results from your controller and keep for future reference.
The SA3-RGB controller is supplied with a 4-pin lead to connect to RGB LED tape which is fed
from the controller via a removable euro-block connector with 4 screw terminals. Ensure that
the R, G, B and V+ connections are matched to the LED tape and swap leads in the terminals
of the euro-block if necessary.
Note: the SA3-RGB controller can operate with 12V or 24V LED tape up to 4A maximum
output per channel red / green / blue (12A total). For longer runs of RGB tape with higher
current requirements, RGB amplifiers with additional power supplies will be necessary.
